Pod 9 Hurupaki School

Pod 9 kite making instructions.

Step 1.

Measure and cut your wood. 50cm &70cm.

1. cut notches in each end

3 on the 50cm piece measure and mark 25cm.

on the 70cm piece measure and mark 18 cm.

1. line the two up in a cross and hot glue them together.make sure your notches are straight .
2. Use string to tie the wood together.
3. Put a bit of hot glue on top of string.
4. put tape around the end of notches.
5. tie string around each notch put a little bit of hot glue on top notch.

9.use rubbish bag and cut it open. 

10.get a meter ruler trace around kite with vivid.

1. cut the traced part out.
2. fold ends down with duck tape fold bottom part of your kite and put duck tape on it.
3. for the ends get another piece of tape put tape on top and fold it.
4. make a bridle out of string.
5. tie around ends of side notches.
6. put a bit of glue on  string of bridle
7. put two holes at the bottom of your kite and put string through the holes
8. cut ribbon and tie ribbons onto the string. 

instructions written by Ava lindsay